Breathable repairs for solid walls
Old walls were built to take on water and let it out again. Repairs that block that movement tend to cause the damp they were meant to cure.
How a solid wall works
Many Regency and Victorian houses around Walmer have solid brick or flint walls without a cavity. They absorb some moisture from rain and ground, and release it by evaporation from the surfaces, particularly through lime-based pointing and plaster. In a sea-facing location, with salt and driving rain, this breathing action matters even more.
The problem with cement
Hard cement mortar and render are strong but not breathable. Used on soft old brick, they can trap moisture and force it to leave through the brick face, which then flakes and crumbles. Impermeable paints and plastic coatings can have a similar effect. The damage may take years to appear, by which time the repair has failed.
Lime mortar and plaster
Lime mortar and plaster are softer, more flexible and allow walls to dry. They have been used for centuries and suit traditional buildings. They need skill to apply and take longer to cure than cement, and work is usually avoided in frost. Ask your builder what they have used on old buildings, and where.
Repointing properly
Repointing means raking out the old mortar to a proper depth and filling with a mortar matched to the brick and the original joint. A joint that is too hard, too wide or too wet can spoil the look and hold water. Repointing should be done only where it is needed, and not to the whole wall as a routine.
Inside the house
Replacing damp or salt-damaged plaster with a breathable lime plaster, and using vapour-permeable paints, helps walls dry. Avoid sealing walls behind tanking or dense boards without advice. Fix the cause of damp first: gutters, ground levels, leaks. A good builder will talk through the options, and a conservation officer or specialist can advise on listed buildings.
Consents
Repairs using matching materials usually do not need consent, but changes to appearance, and most work on listed buildings, do. Check with Dover District Council if your house lies within a conservation area or is listed. Using the right materials and methods is more than a matter of looks.
Render, paint and coatings
Old render was often lime-based, and was meant to shed water and dry out. Replacing it with a hard cement render, or painting it with an impermeable masonry paint, can trap damp. When the surface needs recoating, ask for mineral or lime-based paints that allow the wall to breathe. Test any proposed product on a small area first, and ask for the technical data.
Insulating old walls
Solid walls lose heat, and insulating them can help, but it must be done with care. Insulation that traps moisture can cause rot in timber built into the wall, such as joist ends. Breathable internal insulation boards and plasters exist, and they need good detailing and ventilation. Take advice before insulating a wall you suspect is damp.
Finding the right tradesperson
Ask whether the builder or plasterer has used lime on old buildings, and ask to see examples after a year or more, not just on the day. Lime work is a skill, and it varies with the weather and the mix. A tradesperson who is confident will talk you through the mix, the curing and the aftercare.
Related
Renovating a Regency or Victorian house near the sea goes further on whole-house work, and the Walmer seafront and castle page describes the setting. See our refurbishment page for the work itself.
Free site visit and quote
Tell us about the project at hello@walmerbuilders.co.uk or on WhatsApp. We'll arrange a site visit to give you a proper quote.